Guardat en:
| Format: | Revista científica |
|---|---|
| Idioma: | RU |
| Publicat: |
Dagestan State Technical University
2017
|
| Matèries: | |
| Accés en línia: | https://doaj.org/toc/2542-095X |
| Etiquetes: |
Afegir etiqueta
Sense etiquetes, Sigues el primer a etiquetar aquest registre!
|
Ítems similars
Development of a C Program for Thermal and Structural Analysis in Die Casting Processes
per: Raju Panchal
Publicat: (2025)
per: Raju Panchal
Publicat: (2025)
MPM and ALE simulations of large deformations geotechnics instability problems
per: Giovanna Monique Alelvan
Publicat: (2020)
per: Giovanna Monique Alelvan
Publicat: (2020)
Temperature distributions in pavement and bridge slabs heated by using vertical ground-source heat pump systems
per: Asim Balbay
Publicat: (2013)
per: Asim Balbay
Publicat: (2013)
Elastic behavior of stiffened curved plates subjected to transverse loading
per: Abel Noguera Garban
Publicat: (2018)
per: Abel Noguera Garban
Publicat: (2018)
Saline distribution during multicomponent salting in pre-cooked quail eggs
per: Dionísio BORSATO
Publicat: (2012)
per: Dionísio BORSATO
Publicat: (2012)
Optimal ratios of the piston speeds for a finite speed endoreversible Carnot heat engine cycle
per: Huijun Feng
Publicat: (2010)
per: Huijun Feng
Publicat: (2010)
Modelling and simulation of a thermoelectric waste heat recovery system - TWRHS
per: Anderson Luis Oliveira Maran
Publicat: (2021)
per: Anderson Luis Oliveira Maran
Publicat: (2021)
Solution of the Inverse Bio-Heat Transfer Problem for a Simplified Dermatological Application: Case of Skin Cancer
per: José Manuel Luna
Publicat: (2014)
per: José Manuel Luna
Publicat: (2014)
Effect of heat transfer on the performance of a thermoelectric heat pump driven by a thermoelectric generator
per: Lingen Chen
Publicat: (2009)
per: Lingen Chen
Publicat: (2009)
Ecological performance optimization of a thermoacoustic heat engine
per: Lingen Chen
Publicat: (2010)
per: Lingen Chen
Publicat: (2010)
Axisymmetric modelling of transient thermal response in solids for application to infrared photothermal radiometry technique
per: J. Hernández-Wong
Publicat: (2019)
per: J. Hernández-Wong
Publicat: (2019)
Experimental behavior of a masonry wall supported on a RC twoway slab
per: Alonso Gómez-Bernal
Publicat: (2015)
per: Alonso Gómez-Bernal
Publicat: (2015)
Vibration Analysis of Rolling Element Bearings Defects
per: H. Saruhan
Publicat: (2014)
per: H. Saruhan
Publicat: (2014)
A transport modeling of the carbon-nitrogen cycle at Igapó I Lake - Londrina, Paraná State, Brazil
per: Suellen Ribeiro Pardo
Publicat: (2012)
per: Suellen Ribeiro Pardo
Publicat: (2012)
Boundary element analysis for primary and secondary creep problems
per: E. Pineda León
Publicat: (2008)
per: E. Pineda León
Publicat: (2008)
Вестник Донского государственного технического университета
Publicat: (2018)
Publicat: (2018)
Analytical Heat Transfer
per: Han, Je-Chin, et al.
Publicat: (2023)
per: Han, Je-Chin, et al.
Publicat: (2023)
Dynamic test for determining the elastic modulus of coffee fruit-stem-branch system
per: Andre Luiz de Freitas Coelho
Publicat: (2017)
per: Andre Luiz de Freitas Coelho
Publicat: (2017)
Application of the factorial design and finite element methods to optimize the solidification of Cu-5wt%Zn alloy in a sand mold
per: M.M. Pariona
Publicat: (2008)
per: M.M. Pariona
Publicat: (2008)
A coupled virtual element-interface model for analysis of fracture propagation in polycrystalline composites
per: Gatta, Cristina, et al.
Publicat: (2024)
per: Gatta, Cristina, et al.
Publicat: (2024)
Aggregation of latex microparticles: simulation and experimental verification
per: Flavio Humberto Fernández Morales
Publicat: (2009)
per: Flavio Humberto Fernández Morales
Publicat: (2009)
Deflexión en arcos usando métodos energéticos
per: Miranda Casazola Dayan Esmirna
Publicat: (2020)
per: Miranda Casazola Dayan Esmirna
Publicat: (2020)
Evaluation of Load Capacity of Stratified Soils (2 Layers) by Means of Numerical Analytical Comparison
per: Jairo-Alejandro Quintero-Chamorro
Publicat: (2021)
per: Jairo-Alejandro Quintero-Chamorro
Publicat: (2021)
Multicomponent diffusion during Prato cheese ripening: mathematical modeling using the finite element method
per: Evandro BONA
Publicat: (2010)
per: Evandro BONA
Publicat: (2010)
A static analysis of the tension and configuration of submerged plane nets
per: Wan, R., Hu, F., Tokai, T
Publicat: (2002)
per: Wan, R., Hu, F., Tokai, T
Publicat: (2002)
Development and analysis of a numerical model of the reinforced concrete expansion due to uniform corrosion
per: E. F. Felix
Publicat: (2020)
per: E. F. Felix
Publicat: (2020)
Influence of damping ratio on a structural optimization design considering a dynamic analysis within the time domain
per: Débora Francisco Lalo
Publicat: (2018)
per: Débora Francisco Lalo
Publicat: (2018)
Robustness and dispersion analysis of the Partition of Unity Finite Element Method applied to the Helmholtz equation
per: Hervella-Nieto, Luis María, et al.
Publicat: (2019)
per: Hervella-Nieto, Luis María, et al.
Publicat: (2019)
CONTACT NOTCH STRESS ASSESSMENT WITHIN FRICTIONAL CONTACT JOINTS
per: DARIUSZ SZWEDOWICZ
Publicat: (2012)
per: DARIUSZ SZWEDOWICZ
Publicat: (2012)
Global optimization algorithms applied in a parameter estimation strategy
per: David Matajira-Rueda
Publicat: (2018)
per: David Matajira-Rueda
Publicat: (2018)
ADVANCING PROBABILISTIC FRAME ANALYSIS: A COMPREHENSIVE APPROACH USING MONTE CARLO SIMULATION AND RESPONSE SURFACES
per: Wilson Rodríguez-Calderón
Publicat: (2024)
per: Wilson Rodríguez-Calderón
Publicat: (2024)
Study of the behavior of a reinforced embankment supported on alluvial soft soil
per: João Alexandre Paschoalin Filho
Publicat: (2013)
per: João Alexandre Paschoalin Filho
Publicat: (2013)
Effect of longitudinal stiffening on bridge girder webs at incremental launching stage
per: C. A. Graciano
Publicat: (2015)
per: C. A. Graciano
Publicat: (2015)
An Analysis of Total Phosphorus Dispersion in Lake Used As a Municipal Water Supply
per: RÔMULO C. LIMA
Publicat: (2015)
per: RÔMULO C. LIMA
Publicat: (2015)
Mechanical characterization of visually graded boards from turkish fir and black pine by nondestructive and destructive tests
per: Fatih Kurul
Publicat: (2024)
per: Fatih Kurul
Publicat: (2024)
Analysis of the use of aluminum pipes for irrigation as an electrical conduit for an underground installation
per: Josnier Ramos Guardarrama
Publicat: (2023)
per: Josnier Ramos Guardarrama
Publicat: (2023)
Composite materials reinforced with ceramic waste and matrix of unsaturated polyester for applications in the automotive industry
per: Jorge Antonio Velasco-Parra
Publicat: (2020)
per: Jorge Antonio Velasco-Parra
Publicat: (2020)
Thermal-Electrical finite element analysis of nanometric copper vias under high fluence stress
per: F. Oviedo
Publicat: (2013)
per: F. Oviedo
Publicat: (2013)
Journal of Heat and Mass Transfer Research
Publicat: (2024)
Publicat: (2024)
International Journal of Advanced Design and Manufacturing Technology
Publicat: (2023)
Publicat: (2023)