Imagen de Portada

The effect of chemical vapor infiltration process parameters on flexural strength of porous α-SiC: A numerical model

Fuente: arXiv

Guardado en:

Detalles Bibliográficos
Autores principales:	Marziale, Joseph J., Sun, Jason, Walker, Eric A., Chen, Yu, Salac, David, Chen, James
Formato:	Preprint
Publicado:	2026
Materias:	Materials Science
Acceso en línea:	Acceder al recurso
Etiquetas:	Agregar Etiqueta Sin Etiquetas, Sea el primero en etiquetar este registro!

Ejemplares similares

The effect of chemical vapor infiltration process parameters on flexural strength of porous α$\alpha$‐SiC: a numerical model
por: Joseph J. Marziale, et al.
Publicado: (2024)

Damage Prediction of Sintered α-SiC Using Thermo-mechanical Coupled Fracture Model
por: Sun, Jason, et al.
Publicado: (2026)

Modeling of industrial isothermal chemical vapor infiltration process for C/SiC structural composites
por: Vijay M. Shinde, et al.
Publicado: (2025)

Influence of polycarbosilane composition on the properties of SiC/SiC composite fabricated by precursor infiltration and pyrolysis process
por: Yi Chen, et al.
Publicado: (2024)

Grid-agnostic volume of fluid approach with interface sharpening and surface tension for compressible multiphase flows
por: Marziale, J., et al.
Publicado: (2026)

High‐strength Si–SiC lattices prepared by powder bed fusion, infiltration‐pyrolysis, and reactive silicon infiltration
por: Marco Pelanconi, et al.
Publicado: (2024)

Oxidation of SiC fibers in water vapor
por: Victoria L. Christensen, et al.
Publicado: (2024)

Microstructure and ablation behavior of C/C–HfC–SiC composites fabricated by reactive melt infiltration with Hf–Si alloy
por: Chongqing Xu, et al.
Publicado: (2024)

Mechanical properties of SiC fiber/carbon/Si‐Co matrix composites processed using film boiling and melt infiltration
por: Takashi Miura, et al.
Publicado: (2024)

Analysis of the effects of interfacial parameters on the thermal conductivity properties of SiC/SMPU composites
por: Xiaoyu Guan, et al.
Publicado: (2024)

Preliminary hyperspectral neutron radiography of binder jet 3D printed and melt infiltrated Si–SiC
por: Corson L. Cramer, et al.
Publicado: (2025)

Densification and optimization of SiC f /SiC composites by low‐temperature NITE process
por: Xu Shen, et al.
Publicado: (2025)

High strength C/Si‒Ni‒C composites fabricated by reaction melt infiltration with Si‒Ni alloy at lower temperature
por: Yiming Chen, et al.
Publicado: (2024)

Effect of PyC/BN interfacial phases on mechanical behavior of SiC/SiC composites
por: Haipeng Qiu, et al.
Publicado: (2024)

Polymer‐derived SiC–ZrC composite ceramic fiber prepared by the BCl3‐curing process
por: Mengna Zhang, et al.
Publicado: (2025)

A Stabilized Diffuse-Interface Electroporation Model with a Semi-Analytical Spectral Electrolyte Solver
por: Seifi, Saman, et al.
Publicado: (2016)

A Modified Hermite Radial Basis Function for Accurate Interpolation
por: Fashamiha, Amirhossein, et al.
Publicado: (2025)

Effect of particle size and Mg content on the processing parameters of Al-Si-Mg/SiCp composites processed by pressureless infiltration
por: J.A. Aguilar-Martínez
Publicado: (2007)

Gelcasting for the densification repair of delamination defects in SiC f /SiC composites
por: Yiran Lin, et al.
Publicado: (2026)

Micro/nanostructure constructed by in situ growth of SiC nanowires in porous Si 3 N 4 ceramics
por: Lizhi Zhang, et al.
Publicado: (2024)

Surface Structuring of Patterned 4H-SiC Surfaces Using a SiC/Si/SiC Sandwich Approach
por: Jousseaume, Yann, et al.
Publicado: (2024)

High‐temperature behavior and self‐enhancing mechanisms of oxide‐bonded SiC porous ceramics
por: Guangyu Zhou, et al.
Publicado: (2024)

Effects of heat treatment on mechanical and thermophysical properties of KD‐SA SiC f /SiC composites
por: Jin Zhang, et al.
Publicado: (2025)

Preparation of jointed composites with interconnected SiC nanowires network for nuclear SiC fiber reinforced SiC composites
por: Meihan Ren, et al.
Publicado: (2024)

Asymptotically proved numerical coupling of a 2D flexural porous plate with the 3D Stokes fluid
por: Krier, Maxime, et al.
Publicado: (2023)

Effect of BN interfacial layer on the mechanical behavior of SiC fiber reinforced SiC ceramic matrix composites
por: Mingwei Chen, et al.
Publicado: (2024)

BN recession and recession cessation in SiC/BN/SiC composites
por: Shingo Kanazawa, et al.
Publicado: (2025)

Enhanced mechanical and wave‐absorption properties of SiC–Si 3 N 4 –FeSi porous ceramics by introducing Al
por: Huihui Zhang, et al.
Publicado: (2024)

Radiation effects on SiC/Al composite material
por: A. Kohyama, et al.
Publicado: (1987)

Thermal explosion synthesis of SiC nanopowders
por: Fei Li, et al.
Publicado: (2025)

Study on laser ablation quality and removal mechanism of SiC f /SiC composites by wavelength and thermal effect equation
por: Juan Song, et al.
Publicado: (2025)

The oxidation life analysis method for SiC/SiC composite components based on an equivalent diffusion coefficient model
por: Xiaoting Shi, et al.
Publicado: (2024)

Detection of the linear SiC$_3$ and SiC$_5$ radicals in IRC\,+10216
por: Cernicharo, José, et al.
Publicado: (2025)

Enhancing flexural strength of ceramics by quenching
por: Junfeng Gu, et al.
Publicado: (2025)

Theoretical study on the effects of Si doping on the interface adhesion and failure behaviors of SiC/BN interface
por: Siyan Zhang, et al.
Publicado: (2025)

Influence of SiC content in B 4 C– n SiC composites corrosion in molten FLiNaK salt at 800°C
por: Kui Wang, et al.
Publicado: (2024)

SiC high‐tech ceramics — a comparison of laser processes
por: Christian Rochholz, et al.
Publicado: (2024)

Study on Grinding Wheel Wear and Machining Quality in Ultrasonic Vibration Helical Grinding of SiC f /SiC Composites
por: Junjie Zhou, et al.
Publicado: (2026)

High‐temperature deformation and consolidation of polycrystalline α‐SiC by spark plasma sintering
por: Dmytro Demirskyi, et al.
Publicado: (2024)

3D‐printed SiC‐microfiber‐reinforced polymer‐derived ceramic with high strength at elevated temperature
por: Brett G. Compton, et al.
Publicado: (2025)