Imagen de Portada

Varying the fault-normal and shear-parallel stiffness during laboratory shear experiments

Fuente: PANGAEA

Guardado en:

Detalles Bibliográficos
Autores principales:	Eijsink, Agathe, Ikari, Matt J
Formato:	Dataset Open Access
Lenguaje:	en
Publicado:	PANGAEA 2023
Materias:	Center for Marine Environmental Sciences; fault stiffness; friction; laboratory friction experiments; MARUM; slip stability
Acceso en línea:	Acceder al recurso
Etiquetas:	Agregar Etiqueta Sin Etiquetas, Sea el primero en etiquetar este registro!

Ejemplares similares

Measured friction coefficients during laboratory shear experiments
por: Eijsink, Agathe, et al.
Publicado: (2023)

Measured rate-and-state friction coefficients, with input parameters for the forward model and the best fit model parameters as obtained by an inverse modelling technique during laboratory shear experiments
por: Eijsink, Agathe, et al.
Publicado: (2023)

Characteristics of all slip events occurring at the final velocity step where the sliding velocity is 10 um/s during laboratory shear experiments
por: Eijsink, Agathe, et al.
Publicado: (2023)

Laboratory Slow Slip Events in Natural Geologic Materials
por: Ikari, Matt J
Publicado: (2019)

(Table 3) Rate-and-state dependent friction parameters from inverse modeling of velocity upsteps
por: Ikari, Matt J
Publicado: (2019)

Stiffness measurements for direct-shear apparatuses
por: Ikari, Matt J, et al.
Publicado: (2022)

(Table 2) Laboratory SSE (Slow Slip Event) measurements
por: Ikari, Matt J
Publicado: (2019)

Frictional and mechanical properties for a wide range of geologic materials related to cation exchange capacity
por: Ikari, Matt J, et al.
Publicado: (2024)

Friction measurements of the cation exchange capacity (CEC) laboratory experiment
por: Ikari, Matt J, et al.
Publicado: (2024)

Frictional data for the experiments performed under a standardized effective normal stress of 10 MPa of samples from IODP Site 375-U1520
por: Eijsink, Agathe, et al.
Publicado: (2022)

Frictional velocity dependence of laboratory shearing experiments
por: Ikari, Matt J, et al.
Publicado: (2020)

Frictional data for the experiments performed under in-situ effective normal stress of samples from IODP Site 375-U1520
por: Eijsink, Agathe, et al.
Publicado: (2022)

Laboratory experiment of cation exchange capacity (CEC) from rock and mineral standards
por: Ikari, Matt J, et al.
Publicado: (2024)

Laboratory shearing experiments and geodetic measurements, offshore New Zealand and plate motion in New Zealand
por: Ikari, Matt J, et al.
Publicado: (2020)

Experiment details of the cation exchange capacity (CEC) laboratory experiment
por: Ikari, Matt J, et al.
Publicado: (2024)

Table 2: Input parameters to model velocity-dependent friction parameters
por: Ikari, Matt J
Publicado: (2020)

Cohesion measurements of the cation exchange capacity (CEC) laboratory experiment
por: Ikari, Matt J, et al.
Publicado: (2024)

Velocity-dependent friction measurements, input parameters for forward modeling of the cation exchange capacity (CEC) laboratory experiment
por: Ikari, Matt J, et al.
Publicado: (2024)

Frictional properties of laboratory shearing experiments
por: Ikari, Matt J, et al.
Publicado: (2020)

Table 1: Model-extracted velocity-dependent friction parameters
por: Ikari, Matt J
Publicado: (2020)

Porosity measurements of the cation exchange capacity (CEC) laboratory experiment
por: Ikari, Matt J, et al.
Publicado: (2024)

Statistics, like duration, stress drop and velocities of the laboratory slip events that occur during the experiments
por: Eijsink, Agathe, et al.
Publicado: (2022)

Laboratory friction experiments on natural samples from IODP site U1520
por: Eijsink, Agathe, et al.
Publicado: (2022)

Slip- and velocity-dependent friction measurements
por: Ikari, Matt J
Publicado: (2020)

Sliding cohesion measurements of the cation exchange capacity (CEC) laboratory experiment
por: Ikari, Matt J, et al.
Publicado: (2024)

Table 3: Friction measurements for calculation of "net" friction velocity dependence
por: Ikari, Matt J
Publicado: (2020)

Laboratory friction measurements of high-grade minerals
por: Ikari, Matt J, et al.
Publicado: (2020)

Slip- and velocity-dependent friction measurements on Tohoku, Japan Trench samples
por: Ikari, Matt J
Publicado: (2020)

Laboratory friction and physical property measurements of halite/shale mixtures
por: Ikari, Matt J
Publicado: (2020)

Velocity-dependent friction measurements, inverse modeling results (Aging Law) of the cation exchange capacity (CEC) laboratory experiment
por: Ikari, Matt J, et al.
Publicado: (2024)

Velocity-dependent friction measurements, inverse modeling results (Slip Law) of the cation exchange capacity (CEC) laboratory experiment
por: Ikari, Matt J, et al.
Publicado: (2024)

Rate- and state-dependent friction parameters
por: Ikari, Matt J
Publicado: (2020)

Laboratory friction measurements of the Waikukupa Thrust, New Zealand
por: Ikari, Matt J
Publicado: (2020)

Frictional Healing Measurements on SAFOD Samples
por: Ikari, Matt J
Publicado: (2020)

Friction velocity dependence, cohesion, and XRD data of marine sediments from IODP Site U1301, Juan de Fuca plate
por: Stanislowski, Katja, et al.
Publicado: (2022)

Friction Measurements on Weak Materials at Plate Rate Velocities
por: Ikari, Matt J, et al.
Publicado: (2020)

Rate-and-state friction parameters for 1 and 2 state variable friction laws on a Nankai Trough megasplay sample
por: Ikari, Matt J, et al.
Publicado: (2026)

Laboratory friction measurements of the Alpine Fault, New Zealand
por: Ikari, Matt J
Publicado: (2020)

Table 4: Measurements of friction slip dependence
por: Ikari, Matt J
Publicado: (2020)

Bidirectional dry friction energy dissipater using layers
por: Miguel Alberto Domínguez-Gurría
Publicado: (2022)