Imagen de Portada

Reinforcement Corrosion Rate and Crack Width Relationship in Concrete Beams Exposed to Simulated Marine Environment

Fuente: Redalyc

Guardado en:

Detalles Bibliográficos
Autor principal:	Y. Hernández
Formato:	Artículo científico
Lenguaje:	en
Publicado:	Asociación Latinoamericana de Control de Calidad, Patología y Recuperación de la Construcción, A. C. 2016
Materias:	Ingeniería Corrosion loaded beams crack widths
Acceso en línea:	Acceder al recurso
Etiquetas:	Agregar Etiqueta Sin Etiquetas, Sea el primero en etiquetar este registro!

Ejemplares similares

Durability analysis of reinforced concrete with loading induced cracks
por: S. M. M. Pinheiro
Publicado: (2021)

A GENERAL ANALYTICAL APPROACH FOR PRESTRESSED AND NON-PRESTRESSED CONCRETE BEAM-COLUMNS REINFORCED WITH BONDED AND UNBONDED COMPOSITES: (I) THEORY
por: J. A. RODRIGUEZ-GUTIÉRREZ
Publicado: (2011)

A comparative experimental investigation of reinforced-concrete pipes under three-edge-bearing test: Spigot and Pocket and Ogee Joint pipes
por: Jefferson Lins da Silva
Publicado: (2018)

Using the linear damage summation hypothesis in determining the endurance limit of titanium alloy
por: Arkadiy A. Skvortsov
Publicado: (2023)

Propagation of Corrosion‐Induced Cracking of the Reinforced Concrete Exposed to Stray Current in Rail Infrastructures
por: Wenjun Zhu, et al.
Publicado: (2025)

Study of Atmospheric Corrosion of Reinforcement Steel in Havana, Cuba.
por: Abel Castañeda
Publicado: (2014)

Methodology to estimate the total sediment transport in mountainous river basins
por: Jacinto Artigas
Publicado: (2006)

Use of the dynamic load test to obtain the pile capacity - the Brazilian experience
por: Tiago de Jesus Souza
Publicado: (2021)

Corrosion Mechanism and Simulation of Q235 Steel in Typical Marine Atmospheric Environment
por: Shuo Cai, et al.
Publicado: (2025)

Passivation of Prestressed Steel in Concrete With Slag and Exposed to Chlorides
por: Sreelakshmi Srinivasan, et al.
Publicado: (2025)

Steady state signatures in the time domain for nonintrusive appliance identification
por: Y. Jimenez
Publicado: (2015)

Exploring Galvanic Corrosion Behavior of CFRP/Q235 Carbon Steel in Marine Environment
por: Yue Hou, et al.
Publicado: (2025)

Nonlinear Corrosion Evolution and Lateral Bearing Capacity Degradation of Steel Tubular Piles Under Marine Environment
por: Wei Shao, et al.
Publicado: (2025)

Corrosion Failure Analysis of 316L Stainless Steel Exposed to the China's Bohai Sea Water‐Air Interfacial Environment for 2.5 years
por: Futai Zhang, et al.
Publicado: (2026)

Performance assessment and impact of electric vehicles penetration in active distribution grids
por: Robles-Lozano, Geolain, et al.
Publicado: (2024)

Determining a Conservative Critical Chloride Concentration for Rebar Corrosion in Simulated Concrete Pore Solution Using Cyclic Potentiodynamic Polarization and Critical Pitting Temperature
por: Chenxi Liu, et al.
Publicado: (2025)

External strengthening of shear deficient beams using AFRP and GFRP Fibers
por: Arya J, et al.
Publicado: (2023)

Study of Global Seawater Corrosivity Classification Based on Marine Environmental Factors Data
por: Penghui Zhang, et al.
Publicado: (2024)

Optimizing the Resistance of Advanced Weathering Steel to Marine Atmospheric Corrosion With the Addition of Al
por: Yitong Yan, et al.
Publicado: (2025)

Ant‐Nest Corrosion Morphology of Deoxidized High Phosphorous Copper and Oxygen‐Free Copper Tubes Exposed to Formic Acid Vapor
por: Eri Akisawa, et al.
Publicado: (2025)

Influence of Oxygen on Copper Corrosion Behavior in Simulated Groundwater
por: Yuting Zhou, et al.
Publicado: (2025)

Corrosion Cracking of 316L Steel Under Fatigue Loading in High‐Temperature Binary Nitrate Salt: Effects of Loading Frequency
por: Deming Wang, et al.
Publicado: (2025)

A Statistical Study Into the Performance of Organic Coatings Over Mechanically Prepared Welds in a Simulated Marine Environment
por: Tom Marquardt, et al.
Publicado: (2025)

Consequences of Cold Drawing and Hot Rolling Processes on Microstructure, Microhardness and Electrochemical Corrosion of Structural Steels in 0.1 M Na 2 SO 4 , 0.1 M NaCl and Simulated Concrete Pore Solutions
por: Feyrouz Trad, et al.
Publicado: (2025)

Improved Galvanic Corrosion Model Considering the Corrosion Product Hindering Characteristic and Maximum Corrosion Depth
por: Shanling Han, et al.
Publicado: (2025)

Long‐Term Marine Atmospheric Exposure of a Carbon Steel From the ‘Lighthouse at the End of the World’: Corrosion and Microstructural Characterization
por: S. B. Farina, et al.
Publicado: (2025)

Corrosion Prediction Approach Combining FEM‐Simulations and AI‐Modules for Complex Automotive Geometries
por: Marcel Gollé‐Leidreiter, et al.
Publicado: (2026)

Effect of Temperature and Oxygen Concentration on Corrosion of J55 Steel in an O2/CO2 Environment
por: Haozhe Ma, et al.
Publicado: (2024)

Hybrid Ceramic–Industrial Waste Reinforced HVOF Coatings for Erosion–Corrosion Protection of Boiler Steels
por: Duraisammy Elango, et al.
Publicado: (2025)

Numerical Simulation of Pipeline Corrosion via Coupled Nonisothermal Turbulent Heat Transfer and Electrochemical Models
por: Hanbing Qi, et al.
Publicado: (2025)

Microstructural Evolution and Corrosion Behaviour of Al7075 Metal Matrix Composites Reinforced With Hexagonal Boron Nitride
por: V. Vignesh Kumar, et al.
Publicado: (2026)

Carbon Fiber‐Reinforced Resin Composite Coating for Inhibiting the Corrosion‐Induced Leakage of Oil and Gas Pipelines
por: Huazhang Li, et al.
Publicado: (2025)

Corrosion Inhibition Behavior of Aluminum Alloy by EDTA Sodium Salts in Simulated HVDC Internal Cooling Water
por: Liangshou Hao, et al.
Publicado: (2026)

Performance Testing, Corrosion Behavior, and Corrosion Product Analysis of Cast Magnesium and Its Alloys
por: Yuwei Song, et al.
Publicado: (2025)

A Mechanistic Model for Predicting Top‐of‐the‐Line Corrosion in CO 2 /H 2 S Environments: Validation and Field Application
por: Farnoosh Khoshandam, et al.
Publicado: (2026)

Corrosion Performance of Prepainted Galvanized Steel After 8‐Year Outdoor Exposure Upon the Distance to the Seashore in Temperate Environment
por: Nathalie LeBozec, et al.
Publicado: (2026)

PREFACE: Special Issue: “Offshore Wind” Corrosion and Corrosion Protection of Offshore Wind Power Structures
por: Andreas Momber, et al.
Publicado: (2025)

Performance of Surface‐Engineered SAE 4140 Valve Stem Steel Under High‐Temperature Cyclic Oxidation and Hot‐Corrosion Environment
por: Pravin Kumar Mishra, et al.
Publicado: (2026)

Evaluation of dose-response relationship between smoking load and cardiopulmonary fitness in adult smokers: A cross-sectional study
por: V.T. Lauria
Publicado: (2017)

Masthead: Materials and Corrosion. 12/2025
Publicado: (2025)