Image de couverture de livre

Bidirectional dry friction energy dissipater using layers

Fuente: Redalyc

Enregistré dans:

Détails bibliographiques
Auteur principal:	Miguel Alberto Domínguez-Gurría
Format:	Artículo científico
Langue:	en
Publié:	Universidad Nacional de Colombia 2022
Sujets:	Ingeniería layers Dry friction energy dissipation variable stiffness
Accès en ligne:	Acceder al recurso 1 Acceder al recurso 2 Acceder al recurso 3 Acceder al recurso 4 Acceder al recurso 5
Tags:	Ajouter un tag Pas de tags, Soyez le premier à ajouter un tag!

Documents similaires

Measured friction coefficients during laboratory shear experiments
par: Eijsink, Agathe, et autres
Publié: (2023)

Measured rate-and-state friction coefficients, with input parameters for the forward model and the best fit model parameters as obtained by an inverse modelling technique during laboratory shear experiments
par: Eijsink, Agathe, et autres
Publié: (2023)

Varying the fault-normal and shear-parallel stiffness during laboratory shear experiments
par: Eijsink, Agathe, et autres
Publié: (2023)

FINITE ELEMENT MODELING OF THE CRACK PROPAGATION IN RC BEAMS BY USING ENERGY APPROACH
par: Shahriar Shahbazpanahi
Publié: (2014)

Kinetic modelling of drying of three varieties of yucca industrial
par: Angélica María Torregroza-Espinos
Publié: (2014)

Characteristics of all slip events occurring at the final velocity step where the sliding velocity is 10 um/s during laboratory shear experiments
par: Eijsink, Agathe, et autres
Publié: (2023)

Онтология динамики: фундаментальные основания
par: Nekludoff, Alexey A.
Publié: (2026)

Experimental behavior of a low-cost seismic energy dissipation device
par: Héctor Guerrero
Publié: (2020)

Numerical assessment of dissipation energy capacity in perforated plate steel dampers
par: Samuel N. Ferrer-Fuenmayor
Publié: (2021)

Kinetic aspects of a dried thin layer carrot in a heat pump dryer
par: Juan Carlos Gómez-Daza
Publié: (2016)

An approach to estimate tidal dissipation with single-point high-frequency ground wave radar data.
par: Mao, Huabin, et autres
Publié: (2012)

Relationships between microfibril angle, modulus of elasticity and compressive strength in Eucalyptus wood
par: Paulo Ricardo Gherardi Hein
Publié: (2012)

Comparative Spectral Dynamic Analysis of Reinforcement with Buckling Restrained Braces and Fluid Viscous Dampers for an Irregular 11-Story Building
par: Olivares, Marco Antonio Ccota, et autres
Publié: (2026)

Método simplificado para el cálculo del factor de carga en conexiones apernadas
par: Denis Alejandro Abarca Quesada
Publié: (2016)

An stiffness coefficients proposal for thin walled open beams
par: Alejandro Ruiz Sibaja
Publié: (2006)

Damage and structural restoration effect in the calculation of structural natural vibration frequencies of petroleum vapor plant
par: Antonio Ramón Sarcos Portillo
Publié: (2007)

The effect of strain hardening on the behavior of the AISI 304 stainless steels alloys under dry friction
par: Rigoberto Reinoza
Publié: (2006)

Domain Wall, Stiff Matter and Ultra-Relativistic Particles from a Generalized Double-Component Dark Energy Model
par: El-Nabulsi Ahmad Rami
Publié: (2010)

Capacitive MEMS accelerometer wide range modeling using artificial neural network
par: A. Baharodimehr
Publié: (2009)

Damage assessment proposal for two bridges located on Highway No. 14 in the State of Sonora México by using stiffness invariant as global comparison parameter
par: G. Ramos-Torres
Publié: (2021)

On the Interface Stiffness in Rough Contacts Using Ultrasonic Waves
par: Miguel González Valadez
Publié: (2008)

Total phenolics, antioxidant capacity, colour and drying characteristics of date fruit dried with different methods
par: Gökçen IZLI
Publié: (2017)

Rectilinear friction
par: Chateauminois, Antoine
Publié: (2026)

Influence of testing methods to determine the bending modulus of elasticity of wood
par: Diogo Aparecido Lopes
Publié: (2015)

DEGREDATION PROPERTIES OF REINFORCED CONCRETE WALLS WITH OPENINGS
par: JULIAN CARRILLO
Publié: (2011)

The structural behaviour of laminated-guadua panels under parallel plane loads
par: J. J. Pinilla
Publié: (2012)

Frictional data for the experiments performed under a standardized effective normal stress of 10 MPa of samples from IODP Site 375-U1520
par: Eijsink, Agathe, et autres
Publié: (2022)

Rayleigh–Type Renormalized Flows in Weighted Geometries Energy Dissipation, Invariance, and Applications to PDE Dynamics
par: Rodrigues de Maria, Mateus
Publié: (2025)

Implementation of the ultrasonic through-transmission technique for the elastic characterization of fiber-reinforced laminated composite
par: Carlos Alberto Meza
Publié: (2019)

Cross-layer designs for energy efficient wireless body area networks: a review
par: Juan Camilo Correa-Chica
Publié: (2016)

Kinetics modeling of the drying of Opuntia ficus indica with solar energy
par: R. LÓpez Callejas
Publié: (2013)

Influence of relative stiffness on the behavior of piled raft foundations
par: Jean Rodrigo Garcia
Publié: (2018)

A comparative experimental investigation of reinforced-concrete pipes under three-edge-bearing test: Spigot and Pocket and Ogee Joint pipes
par: Jefferson Lins da Silva
Publié: (2018)

Frictional data for the experiments performed under in-situ effective normal stress of samples from IODP Site 375-U1520
par: Eijsink, Agathe, et autres
Publié: (2022)

Design, modeling and dynamic simulation of three double stage gearboxes with different module, mesh stiffness fluctuation and different level tooth breakage
par: Jairo Alberto Ruiz-Boter
Publié: (2015)

Elastic stiffness coefficients of Bakken Petroleum System cores
par: Firdaus, Gama, et autres
Publié: (2021)

Analysis and stiffness evaluation of a microparallel kinematic machine
par: Ricardo Yañez-Valdez
Publié: (2017)

On the Nature of the Cartesian Stiffness Matrix
par: Jorge Angeles
Publié: (2010)

Energy efficiency performance enhancement of industrial conventional wood drying kiln by adding forced ventilation and waste heat recovery system: A comparative study
par: Yang Meng
Publié: (2019)

Optimal emergency vehicle braking control based on dynamic friction model
par: L. Olmos
Publié: (2005)