Imagen de Portada

Strain hardening of crystalline materials

Fuente: Redalyc

Guardado en:

Detalles Bibliográficos
Autor principal:	Edison A. Bonifaz
Formato:	Artículo científico
Lenguaje:	en
Publicado:	Universidad San Francisco de Quito 2010
Materias:	Multidisciplinaria (Ciencias Naturales y Exactas) Dislocations grain boundary finite element method polycrystalline behavior
Acceso en línea:	Acceder al recurso
Etiquetas:	Agregar Etiqueta Sin Etiquetas, Sea el primero en etiquetar este registro!

Ejemplares similares

Boundary element analysis for primary and secondary creep problems
por: E. Pineda León
Publicado: (2008)

An Analysis of Total Phosphorus Dispersion in Lake Used As a Municipal Water Supply
por: RÔMULO C. LIMA
Publicado: (2015)

Multiscale Simulations in Welds
por: Edison A. Bonifaz
Publicado: (2012)

Dynamic Analysis of Complex Structures Based on Octree Scaled Boundary Finite Element Method
por: Jamil, Kazi Md Shah, et al.
Publicado: (2026)

A model for coupled electro-hydro-mechanical processes in fine grained soils accounting for gas generation and transport
por: Claudio Tamagnini
Publicado: (2010)

A transport modeling of the carbon-nitrogen cycle at Igapó I Lake - Londrina, Paraná State, Brazil
por: Suellen Ribeiro Pardo
Publicado: (2012)

Axisymmetric modelling of transient thermal response in solids for application to infrared photothermal radiometry technique
por: J. Hernández-Wong
Publicado: (2019)

Dynamic test for determining the elastic modulus of coffee fruit-stem-branch system
por: Andre Luiz de Freitas Coelho
Publicado: (2017)

A coupled virtual element-interface model for analysis of fracture propagation in polycrystalline composites
por: Gatta, Cristina, et al.
Publicado: (2024)

Aggregation of latex microparticles: simulation and experimental verification
por: Flavio Humberto Fernández Morales
Publicado: (2009)

Multicomponent diffusion during Prato cheese ripening: mathematical modeling using the finite element method
por: Evandro BONA
Publicado: (2010)

Development and analysis of a numerical model of the reinforced concrete expansion due to uniform corrosion
por: E. F. Felix
Publicado: (2020)

Evaluation of Load Capacity of Stratified Soils (2 Layers) by Means of Numerical Analytical Comparison
por: Jairo-Alejandro Quintero-Chamorro
Publicado: (2021)

A static analysis of the tension and configuration of submerged plane nets
por: Wan, R., Hu, F., Tokai, T
Publicado: (2002)

Deflexión en arcos usando métodos energéticos
por: Miranda Casazola Dayan Esmirna
Publicado: (2020)

Thermal-Electrical finite element analysis of nanometric copper vias under high fluence stress
por: F. Oviedo
Publicado: (2013)

Composite materials reinforced with ceramic waste and matrix of unsaturated polyester for applications in the automotive industry
por: Jorge Antonio Velasco-Parra
Publicado: (2020)

MPM and ALE simulations of large deformations geotechnics instability problems
por: Giovanna Monique Alelvan
Publicado: (2020)

CONTACT NOTCH STRESS ASSESSMENT WITHIN FRICTIONAL CONTACT JOINTS
por: DARIUSZ SZWEDOWICZ
Publicado: (2012)

Influence of damping ratio on a structural optimization design considering a dynamic analysis within the time domain
por: Débora Francisco Lalo
Publicado: (2018)

Robustness and dispersion analysis of the Partition of Unity Finite Element Method applied to the Helmholtz equation
por: Hervella-Nieto, Luis María, et al.
Publicado: (2019)

Determinación de elementos mayores en sedimentos provenientes de zonas afectadas por actividades petroleras en Ecuador
por: Cristina Gabriela Pérez Naranjo
Publicado: (2015)

Effect of longitudinal stiffening on bridge girder webs at incremental launching stage
por: C. A. Graciano
Publicado: (2015)

Study of the behavior of a reinforced embankment supported on alluvial soft soil
por: João Alexandre Paschoalin Filho
Publicado: (2013)

ADVANCING PROBABILISTIC FRAME ANALYSIS: A COMPREHENSIVE APPROACH USING MONTE CARLO SIMULATION AND RESPONSE SURFACES
por: Wilson Rodríguez-Calderón
Publicado: (2024)

Mechanical characterization of visually graded boards from turkish fir and black pine by nondestructive and destructive tests
por: Fatih Kurul
Publicado: (2024)

Analysis of the use of aluminum pipes for irrigation as an electrical conduit for an underground installation
por: Josnier Ramos Guardarrama
Publicado: (2023)

Вестник Дагестанского государственного технического университета: Технические науки
Publicado: (2017)

Improved bounds for the effective energy of nonlinear 3D conducting composites
por: A. León-Mecías
Publicado: (2007)

Development of a C Program for Thermal and Structural Analysis in Die Casting Processes
por: Raju Panchal
Publicado: (2025)

Core influence on the frequency response analysis (FRA) of power transformers through the finite element method
por: D.L. Alvarez
Publicado: (2015)

Structural health monitoring using the Firefly optimization algorithm and finite elements
por: Octavio Andrés González-Estrada
Publicado: (2020)

Temperature distributions in pavement and bridge slabs heated by using vertical ground-source heat pump systems
por: Asim Balbay
Publicado: (2013)

SHAPE AND CELL WALL SLENDERNESS EFFECTS ON THE STIFFNESS OF WOOD CELL AGGREGATES IN THE TRANSVERSE PLANE
por: Alp Karakoҫ
Publicado: (2016)

Dimension Estimation of Rectangular Cracks Using Impedance Changes of the Eddy Current Probe with a Neural Network
por: A. Babaei
Publicado: (2013)

Tailoring nonlinearity and dispersion of photonic crystal fibers using hybrid cladding
por: Liu Zhao-lun
Publicado: (2009)

Mechanical characterization of jute fiber-based biocomposite to manufacture automotive components
por: J. A. Velasco-Parra
Publicado: (2021)

Spectral discretizations of the Darcy’s equations with non standard boundary conditions
por: J. M. Bernard
Publicado: (2018)

The effect of soil stiffness variations on Tunnel Lining Internal Forces under seismic loading and Case comparison with existing analytical methods
por: Reza Zamani
Publicado: (2015)

Application of particle swarm optimization in inverse finite element modeling to determine the cornea ́s mechanical behavior
por: Ricardo Magalhães
Publicado: (2017)