Imagen de Portada

Model‐ versus data‐uncertainty for concrete members and connections in cyclic loading

Fuente: Wiley Open Access

Guardado en:

Detalles Bibliográficos
Autor principal:	Michael N. Fardis
Formato:	Artículo Open Access
Publicado:	Wiley 2024
Materias:	Earthquake Engineering & Structural Dynamics
Acceso en línea:	Acceder al recurso
Etiquetas:	Agregar Etiqueta Sin Etiquetas, Sea el primero en etiquetar este registro!

Ejemplares similares

Shear Resistance of RC Beam‐Column Joints in the Face of Uncertainty
por: Michael N. Fardis
Publicado: (2026)

Dynamic cyclic loading tests for investigating the influence of loading rate and axial force on the lateral response of RC columns
por: Jamin Park, et al.
Publicado: (2024)

Lateral load response and collapse probability of reinforced concrete shear walls retrofitted for repairability
por: Pinar Okumus, et al.
Publicado: (2024)

Uniaxial material model with softening for simulating the cyclic behavior of steel tubes in concrete‐filled steel tube beam‐columns
por: Shiye Wang, et al.
Publicado: (2024)

Quantification of modeling uncertainty in the Rayleigh damping model
por: Farid Ghahari, et al.
Publicado: (2024)

Probabilistic risk assessment for reinforced concrete frame structures subject to mainshock‐aftershock sequences
por: Zhou Zhou, et al.
Publicado: (2024)

Impact of failure mode uncertainty on seismic fragility and collapse risk of buildings
por: Eyitayo A. Opabola, et al.
Publicado: (2024)

Direct loss‐based seismic design of low‐rise base‐isolated reinforced concrete buildings
por: Diego Suarez, et al.
Publicado: (2024)

Local and global integrative retrofitting of reinforced concrete frames using in‐plane buckling steel braces
por: Devyani Tewatia, et al.
Publicado: (2024)

Efficient seismic fragility analysis considering uncertainties in structural systems and ground motions
por: Jungho Kim, et al.
Publicado: (2024)

Inductive graph‐based long short‐term memory network for the prediction of nonlinear floor responses and member forces of steel buildings subjected to orthogonal horizontal ground motions
por: Yuan‐Tung Chou, et al.
Publicado: (2024)

In‐plane and out‐of‐plane seismic performance and damage evaluation of reinforced concrete shear wall structures subjected to mainshock‐aftershock sequences
por: Yang Cheng, et al.
Publicado: (2024)

Sub‐assemblage testing and fragility analysis of connections of continuous‐plasterboard suspended ceiling systems
por: Venkatesh Patnana, et al.
Publicado: (2024)

Shake table testing and finite element modeling of a modular prefabricated concrete bridge‐like specimen accounting for geometry imperfections and additional damping
por: Antonios A. Katsamakas, et al.
Publicado: (2024)

Theoretical model of ultimate shear capacity and flexural capacity design method of boundary elements for reinforced concrete frames with steel plate shear walls
por: Yonghui An, et al.
Publicado: (2024)

Target‐drift seismic‐force‐based design of one‐story reinforced concrete precast buildings considering the requirements of the second generation of the Eurocode 8 standard
por: Tatjana Isaković
Publicado: (2024)

Performance‐based optimum seismic design of self‐centering steel moment frames with SMA‐based connections
por: Aydin Hassanzadeh, et al.
Publicado: (2024)

SSI‐induced seismic earth pressures on an integral abutment bridge model: Experimental measurements versus numerical simulations and code provisions
por: Gabriele Fiorentino, et al.
Publicado: (2024)

Model Development and Validation for a Seismic Isolation System for Lightweight Structures
por: Sebastian Lopez Restrepo, et al.
Publicado: (2025)

The Built Environment Data platform for experimental test data in earthquake engineering
por: Davit Shahnazaryan, et al.
Publicado: (2024)

Hybrid surrogate model combining physics and data for seismic drift estimation of shear‐wall structures
por: Yifan Fei, et al.
Publicado: (2024)

Shake table testing of a seismic isolation system for lightweight structures
por: Sebastian Lopez Restrepo, et al.
Publicado: (2024)

Testing seismic isolators for the effect of maximum earthquake based on measure of cumulative energy
por: Hyun‐Myung Kim, et al.
Publicado: (2024)

The dynamic behaviour of flexible oscillators rocking and sliding on concentrated springs
por: Zheng‐You Zhang, et al.
Publicado: (2024)

Hybrid data‐driven and physics‐based simulation technique for seismic response evaluation of steel buckling‐restrained braced frames considering brace fracture
por: Ali Sadrara, et al.
Publicado: (2024)

Generalized Ordinal Regression Models for Seismic Fragility Analysis
por: Libo Chen
Publicado: (2025)

Modeling the Multiaxial Behavior of High Damping Rubber Bearings (HDRBs)
por: José A. Gallardo, et al.
Publicado: (2025)

Quantifying Model Selection Uncertainty in Structural Analysis: Methodology and Application
por: Ya‐Heng Yang, et al.
Publicado: (2026)

Modelling reinforced masonry buildings by a mechanics‐based macroelement approach
por: Stefano Bracchi, et al.
Publicado: (2024)

Model reference adaptive hierarchical control framework for shake table tests
por: Zhongwei Chen, et al.
Publicado: (2024)

Real‐Time Hybrid Simulation With EGO‐Based Online Model Updating
por: Weipeng Zhong, et al.
Publicado: (2025)

Risk‐Based Model for Post‐Earthquake Functional Recovery of Bridge Networks
por: Chenhao Wu, et al.
Publicado: (2026)

Regional Adjustments to NGA‐West2 Ground‐Motion Models for Turkey
por: Mao‐Xin Wang, et al.
Publicado: (2026)

Generalised Kinematic Single‐Impact and Multi‐Impact Models for Rocking Structures
por: Georgios Vlachakis, et al.
Publicado: (2026)

The Built Environment Data Framework for Simulated Design and Vulnerability Modelling in Earthquake Engineering
por: Volkan Ozsarac, et al.
Publicado: (2025)

Online Cyber‐Physical Neural Network Model for Real‐Time Hybrid Simulation
por: Faisal Nissar Malik, et al.
Publicado: (2025)

Unified Hysteresis Modeling via Physics‐Based Deep Learning and Data Augmentation
por: Jaehwan Jeon, et al.
Publicado: (2025)

Three‐Dimensional Analytical Model of a Free‐Standing Square Rocking Column
por: Dimitra Adamopoulou, et al.
Publicado: (2026)

Wavelet‐Based Stochastic Model for the Generation of Fully Nonstationary Bidirectional Seismic Accelerograms
por: Hera Yanni, et al.
Publicado: (2025)

Covariance Structure Modeling of Engineering Demand Parameters in Cloud‐Based Seismic Analysis
por: Archie Rudman, et al.
Publicado: (2026)