Imagen de Portada

Analysis of energy and exergy of lavender extract powder in spray dryer

Fuente: Wiley Open Access

Guardado en:

Detalles Bibliográficos
Autores principales:	Hossein Meshkat, Faroogh Sharifian, Adel Hosainpour, Ali Mohammad Nikbakht, Mohammad Kaveh
Formato:	Artículo Open Access
Publicado:	Wiley 2024
Materias:	Heat Transfer
Acceso en línea:	Acceder al recurso
Etiquetas:	Agregar Etiqueta Sin Etiquetas, Sea el primero en etiquetar este registro!

Ejemplares similares

Energy and exergy analysis of drying terebinth in a far infrared‐rotary dryer using response surface methodology
por: Mohammad Kaveh, et al.
Publicado: (2024)

Novel mixed solar cooker: Experimental, energy, exergy, and economic analysis
por: Assam Benbaha, et al.
Publicado: (2024)

Experimental and simulation studies on the no‐load performance assessment of a domestic solar dryer
por: Shimpy, et al.
Publicado: (2024)

Effect of fluid flow behavior on sustainability and exergy efficiency of solar heat collectors having multiple V‐ribs with gaps
por: Rajesh Maithani, et al.
Publicado: (2024)

Thermoeconomic Analysis and Optimization of Claude Hydrogen Liquefaction Cycle Integrated With Helium‐Based Joule‐Brayton Precooling Cycle in Novel Geothermal Multigeneration System
por: Ali Eyvazi, et al.
Publicado: (2025)

Examining the impact of filling ratio on thermosyphon performance in passive energy recovery processes with dual effects of evaporative cooling: An experimental study
por: Ahmed Mohsin ALsayah, et al.
Publicado: (2024)

Energy‐Exergy‐Economic‐Environmental Analysis of an Innovative Multibasin Solar Still Absorber: Experimental and Computational Study
por: Zouhayar Al Adel, et al.
Publicado: (2026)

Optimization of Rectangular Microchannel Heat Sinks for Non‐Uniform Heat Flux Removal
por: Nahid Taheri, et al.
Publicado: (2026)

Optimizing diesel engines with oxyhydrogen dual fuel: Enhancing performance with green methyl ester using MCDM techniques
por: P. Ajay Goud, et al.
Publicado: (2024)

Experimental and Numerical Study of Optimization of Perforated Ribs Geometry and Configuration Using Taguchi Approach
por: Mohsen Babamir, et al.
Publicado: (2025)

Modeling and Optimization of Quality Properties of Lentils During the Hot Air Drying Process Utilizing the Response Surface Methodology (RSM)
por: Mohammad Tahmasebi, et al.
Publicado: (2025)

Thermal Performance of a PCM‐Filled Finned Tube Heat Exchanger for Energy Recovery of Hot Exhaust Gases
por: Mohaddeseh Rajabzadeh, et al.
Publicado: (2025)

CFD Analysis of Dual‐Layer PCM Roofs for Thermal Mitigation in Residential Buildings
por: Mohammad Junaid, et al.
Publicado: (2026)

Design and Optimization of a Compact U‐Shaped Internal‐Condenser Heat‐Pipe Heat Exchanger for High‐Ventilation Heating, Ventilation, and Air Conditioning in Hot–Dry Climates
por: Noora S. Mahdi, et al.
Publicado: (2026)

Nutritional Composition and Energy Evaluation of Fruit and Vegetable Waste for Livestock Feed Applications
por: Zahra Atakeshizadeh, et al.
Publicado: (2026)

Numerical and Experimental Analysis of Fin Geometry Effects on Heat Sink Performance in Thermoelectric Air‐Cooling Systems
por: Ali M. Ashour, et al.
Publicado: (2025)

Enhancement of Heat Transfer in a Cavity Containing a Periodically Moving Flexible Fin: Application of NEPCM
por: Nehila Tarek, et al.
Publicado: (2025)

Numerical Investigation of Vibration‐Assisted Heat Transfer Under Sinusoidal and Square Wave Shapes for Potential Reductions in the Heat Sink and Cooling System Size
por: Ambagaha Hewage Dona Kalpani Rasangika, et al.
Publicado: (2025)

Numerical Analysis of Mixed Convection in Vented Curved Cavity With a Metal Foam Layer
por: Luma F. Ali, et al.
Publicado: (2026)

Optimization of L‐ and C‐Shaped Enclosures for Natural Convection Flow: Thermal Performance and Irreversibility Analysis by Using Finite Element Method in FEniCS
por: Mehran Sharifi, et al.
Publicado: (2025)

Mixed convective heat transfer in a square cavity filled with power‐law fluids under active flow modulation
por: Md. Nasim Mia, et al.
Publicado: (2024)

Nonlinear Analysis of Mixed Convection Flow With Temperature‐Dependent Suction Over a Vertical Surface
por: Sadaf Rubab, et al.
Publicado: (2026)

Numerical Analysis of the Thermal Performance of a Hybrid Heat Sink Comprised of Perforated Foam Fins Embedded Within a Phase Change Material
por: Ali Hussein F. Theeb, et al.
Publicado: (2024)

Deep Learning Approach on Numerical Analysis of Time‐Based Flow Over a Decelerating Rotating Disk With Newtonian Heating
por: Amar Rauf, et al.
Publicado: (2025)

Numerical Investigation of Single Slope Solar Still Performance With Different Designs: Energy, Exergy, Economic and Environmental Analysis, and Optimization
por: Muntadher Mohammed Ali Saeed, et al.
Publicado: (2025)

Fluid‐Structure Interaction and Heat Transfer Characteristics of a Thin Flexible Heater Submersed in Non‐Newtonian Fluids Inside a Shear‐Driven Cavity
por: Asif Shorforaj Chowdhury, et al.
Publicado: (2025)

Performance, Exergy, and Economic Analysis of an Evaporative Cooling System With Air Gap: An Experimental Investigation
por: Abdelrahman M. Mourad, et al.
Publicado: (2025)

Analysis of Roll‐Coating Process for Nonisothermal Flow of Non‐Newtonian Fluid in the Presence of a Fixed Constraining Boundary: A Perturbative and Numerical Study
por: Mujahid Islam, et al.
Publicado: (2025)

Numerical Study of the Effect of an Exponentially Increasing Pressure Gradient on Heat Transfer in Non‐Newtonian Fluid Flow Around a Slender Cylinder
por: Sadaqat Ali, et al.
Publicado: (2025)

Thermal Performance and Melting Behavior of Partially Funnel‐Shaped Anisotropic Copper Foam/Paraffin PCM Within an LHTES
por: Masoud Mozaffari, et al.
Publicado: (2025)

A Heatmap and Sensitivity Analysis of Melting‐Induced Swirl Flow Over a Stretchable Oscillatory Disk
por: Tahir Mushtaq, et al.
Publicado: (2025)

Enhancing heat transfer in MHD Falkner's‐Skan flow with thermal radiation, free convection and dusty fluid between parallel plates
por: Dolat Khan, et al.
Publicado: (2024)

AI‐Enhanced Design of Hexagonal Shell and Finned Tube Latent Heat Storage System Using Nonuniform Longitudinal Fins and Nanomaterials During Melting
por: Pouyan Talebizadehsardari, et al.
Publicado: (2025)

Analysis of FHD Flow and Advanced Thermal Management in Rotating Disk Mechanisms Under Radiative Heat Source Interactions Using an SOR–ANN Hybrid Scheme
por: Amar Rauf, et al.
Publicado: (2026)

Application of the image‐well method for transient borehole thermal energy storage systems with complex boundaries
por: Ying‐Fan Lin, et al.
Publicado: (2024)

Couette flow of viscoelastic dusty fluid through a porous oscillating plate in a rotating frame along with heat transfer
por: Gohar Ali, et al.
Publicado: (2024)

Heat transfer analysis of solar distillation system by incorporating nano‐enhanced PCM as thermal energy‐storage system
por: Varun Kumar Singh, et al.
Publicado: (2024)

Natural Convective Heat Transfer in Inclined Enclosures Filled With Power‐Law Fluids: A CFD Study
por: Muhammad Abdullah, et al.
Publicado: (2026)

A novel approach for the active‐mode indirect drying of food grains with high temperature thermal energy storage system
por: Ashutosh Verma, et al.
Publicado: (2024)

Radiant energy exchange through participating media composed of arbitrary concentrations of H2O, CO2, and CO
por: Yanan Camaraza‐Medina, et al.
Publicado: (2024)