Imagen de Portada

Innovative Enhancements for Hemispherical Solar Stills: Enhancing Performance With Copper Conical Fins and Red Brick Fillings

Fuente: Wiley Open Access

Guardado en:

Detalles Bibliográficos
Autores principales:	Mohammed El Hadi Attia, Abd Elnaby Kabeel, M. A. Elazab, M. G. Mousa
Formato:	Artículo Open Access
Publicado:	Wiley 2024
Materias:	Heat Transfer
Acceso en línea:	Acceder al recurso
Etiquetas:	Agregar Etiqueta Sin Etiquetas, Sea el primero en etiquetar este registro!

Ejemplares similares

Reimagining Solar Desalination: A Critical Review of Innovations in Spherical Solar Still Design and Performance
por: Ahmed Kadhim Hussein, et al.
Publicado: (2026)

AI‐Guided Segmented Water Cooling for Photovoltaic Panels: A Novel Approach to Enhance Thermal Management and Electrical Efficiency
por: Ehab M. Almetwall, et al.
Publicado: (2026)

Numerical Investigation of Pyramid Solar Stills with PCM‐Nanoparticles and Absorber Fins: Enhanced Thermal Performance for Sustainable Water Desalination
por: Angham Fadil Abed, et al.
Publicado: (2024)

Improving the Conventional Solar Still Performance by Floating Absorbers, Reflectors, and Nanoparticles‐Improved PCM
por: Habib Ben Bacha, et al.
Publicado: (2026)

Thermal Analysis of a Functionally Graded Conical Fin by Wavelets and Spectral Method
por: S. Lalith Kumar, et al.
Publicado: (2025)

Numerical and Experimental Modeling of a Low‐Cost Square Pyramid Solar Still in Baghdad
por: Ansam Adil Mohammed, et al.
Publicado: (2026)

Numerical Investigation of Single Slope Solar Still Performance With Different Designs: Energy, Exergy, Economic and Environmental Analysis, and Optimization
por: Muntadher Mohammed Ali Saeed, et al.
Publicado: (2025)

Assessing the Feasibility of a Novel Solar Still With Fins, Phase Change Materials, and Wick Materials for Sustainable Water Production
por: Trinath Mahala, et al.
Publicado: (2024)

Thermal Performance Evaluation of Moving Inclined Pin‐Fins in Fully Wet Conditions: A Comparative Analysis of Cylindrical and Conical Geometries
por: Gowtham Kalkere Jayanna, et al.
Publicado: (2026)

Optimization of Thermal Performance by Enhancing Natural Convection of Diverse Configurations of Fin Heat Sink Filled With Nano‐Enhanced Phase Change Materials: A Numerical Study
por: Mallik Nadim Arman Omi
Publicado: (2024)

Thermal Performance of a PCM‐Filled Finned Tube Heat Exchanger for Energy Recovery of Hot Exhaust Gases
por: Mohaddeseh Rajabzadeh, et al.
Publicado: (2025)

Effect of Tray Geometry on Multitray Stepped Solar Still Performance: An Experimental Study
por: Ahmed Rahmani, et al.
Publicado: (2024)

Energy‐Exergy‐Economic‐Environmental Analysis of an Innovative Multibasin Solar Still Absorber: Experimental and Computational Study
por: Zouhayar Al Adel, et al.
Publicado: (2026)

The Solar Still Cover Cooling With Different Technologies: A Review
por: Umar F. Alqsair, et al.
Publicado: (2026)

Hydrothermal Performance Enhancement of Minichannel Heat Sink With Inline and Staggered Arrangements of Straight and Wavy Fins
por: Noor Ahmed Ammar, et al.
Publicado: (2025)

Experimental and Numerical Investigation of the Effect of Interrupted, Inclined, and Staggered Rectangular‐Fin Arrays on Heat Sink Performance
por: Abbas J. Jubear Al‐Jassani, et al.
Publicado: (2025)

Performance Evaluation of Nanoparticle Dispersed Phase Change Material Charging in Thermal Energy Storage System Featuring Longitudinal Fins
por: Ammar M. Abdulateef, et al.
Publicado: (2026)

Performance Analysis of Nature‐Inspired Branched Fins for Rapid Charging in Double‐Pipe Latent Heat Thermal Energy Storage Systems
por: Hayder I. Mohammed
Publicado: (2026)

Numerical Enhancement of Forced Convection Heat Transfer Characteristics for Skewed Wavy Channel Partially Inserted With Copper Metal Foam
por: Nooralhuda A. Mohammed, et al.
Publicado: (2025)

Design and Testing of a Single‐Slope Solar Still With a Semi‐Elliptical Absorbent Base: An Experimental and Numerical Study
por: Muntadher Mohammed Ali Saeed, et al.
Publicado: (2025)

AI‐Enhanced Design of Hexagonal Shell and Finned Tube Latent Heat Storage System Using Nonuniform Longitudinal Fins and Nanomaterials During Melting
por: Pouyan Talebizadehsardari, et al.
Publicado: (2025)

Performance Assessment of Single Slope Solar Still Using Sinusoidal‐Shaped Basin Liners With Phase Change Materials
por: Kumar Rahul, et al.
Publicado: (2025)

Geometric Optimization of Internal Fins for Improved Melting Performance of Nano‐Enhanced PCM in Thermal Energy Storage Systems
por: Ilias Benyahia, et al.
Publicado: (2026)

Enhancement of Thermohydraulic Performance in 3D Annulus Based on Different Configurations of Copper Metal Foam
por: Donia Bassem Hamad, et al.
Publicado: (2026)

Experimental and Numerical Study of the Design and Testing of a Single‐Slope Solar Still With a Semicircular Base: A Comparative Study
por: Hussein Awad Kurdi Saad, et al.
Publicado: (2026)

Optimization of Fill Ratio and Angle Improved Energy Efficiency in Two‐Phase Copper Heat Pipes
por: Wasurat Bunpheng, et al.
Publicado: (2026)

Simultaneous Forced Convective Heat and Mass Transfer of Hot Air Flow Across a Humid‐Packed Bed
por: A. Abd El Badie, et al.
Publicado: (2026)

Numerical and Experimental Analysis of Fin Geometry Effects on Heat Sink Performance in Thermoelectric Air‐Cooling Systems
por: Ali M. Ashour, et al.
Publicado: (2025)

Synergetic Effect of Rubber Sheet and Jute Cloth on Solar Thermal Evaporation From Inclined Solar Still: An Experimental Approach
por: Pitchaiah Sudalaimuthu, et al.
Publicado: (2026)

Application of Advanced Techniques in Double Slope Solar Stills: An Experimental Study in Iraqi Climates
por: Mariam E. Murad, et al.
Publicado: (2025)

On the solution of MHD Jeffery–Hamel problem involving flow between two nonparallel plates with a blood flow application
por: Atallah El‐Shenawy, et al.
Publicado: (2024)

Enhancement of Heat Transfer in a Cavity Containing a Periodically Moving Flexible Fin: Application of NEPCM
por: Nehila Tarek, et al.
Publicado: (2025)

Thermal Performance and Irreversibility in an MHD Baffles Annulus With a Rotating Cylinder: For Advanced Cooling in Nuclear and Electronic Applications
por: Mohammed Sarfaraz Hussain, et al.
Publicado: (2026)

Optical and Thermal Performance Enhancement of a Parabolic Trough Solar Collector With Helical Turbulators and Modified Receiver Geometries
por: Kadhim H. Suffer, et al.
Publicado: (2026)

Enhancing the Performance of an Indirect Solar Dryer Based on Baffle Geometry Optimization: An Experimental Study on Mint Drying Under Saharan Climate
por: Noureddine Meneceur, et al.
Publicado: (2026)

Optimizing Minichannel Heat Sink Design: A Combined Numerical and Experimental Analysis of Inlet/Outlet Configurations and Pin Fin Enhancements
por: Hind Mahmood, et al.
Publicado: (2024)

Design of Experiments to Optimize the Thermal Performance of Finned Absorber Tubes in Parabolic Trough Collectors
por: Raghad Alazawi, et al.
Publicado: (2025)

A Review of Enhancing Heat Transfer in Phase Change Material Using Fin Configurations
por: Rousl S. Jabaar, et al.
Publicado: (2025)

A Computational Analysis of Air‐Cooled Heat Sinks Designs for PV Solar Panel Cooling With Different Fin Numbers
por: Abdullah Al Hasan, et al.
Publicado: (2024)

Parametric Study of Natural Convection in a Nanofluid‐Filled Square Cavity Containing a Hexagonal Heated Obstacle Using Multi‐Relaxation‐Time‐Lattice Boltzmann Method
por: Abdelilah Makaoui, et al.
Publicado: (2026)