Effect of Heat Treatment on the Fatigue of Laser‐Powder Bed Fused Ti‐6Al‐2Sn‐4Zr‐2Mo Alloy

Documenti analoghi

• Rotating Bending Fatigue of Laser Powder Bed Fused 316L Stainless Steel at Various Stress Levels: Microstructural Evaluation and Predictive Modeling
  di: Yahya Aghayar, et al.
  Pubblicazione: (2024)
• Effect of Build Orientation on the Fatigue Limit of CX Steel by Laser Powder Bed Fusion
  di: Mattia Mele, et al.
  Pubblicazione: (2025)
• Influence of the TiO 2 Oxide Layer Phase Composition on the Fatigue Behavior of Heat‐Resistant Titanium Alloys
  di: Maksim Kalienko, et al.
  Pubblicazione: (2026)
• Synergistic Improvement of Fatigue Performance in Laser Powder Bed Fusion 316L Steel Through Heat Treatment and Low‐Temperature Gaseous Carburizing
  di: Yajian Feng, et al.
  Pubblicazione: (2025)
• On the notch sensitivity of as‐built Laser Beam Powder Bed–Fused AlSi10Mg specimens subjected to Very High Cycle Fatigue tests at ultrasonic frequency up to 109 cycles
  di: Andrea Tridello, et al.
  Pubblicazione: (2024)